PACK CONTENTS & FITTING INSTRUCTIONS
LOW MOUNT SOLID RAIL
Revision 2, March 2020
LRSA2-FI
M8 FLAT WASHER
(22-0195)
x12
M8 SPRING WASHER
(22-0162)
x12
M8 HEX NUT
(22-0139)
x12
UNDER-COVER STRIP
(32-0050)
x2
INTERCONNECTING BLOCK
(25-0312)
x3
for
TFT1212, TFT1512 & TFT1812
x4
for TFT 2014
LOW MOUNT WITH END CAPS
x4 (25-0310
- 2 pack
)
Each Low Mount contains
two end caps
RAIL STRAP
x4
NOTE:
Fasteners supplied with Titan Tray are required for this fitment.
RUBBER PAD
(30-0030)
x4
2
Place tray upside down. Remove fasteners on one side and
remove the end plank.
3
For TFT1212, TFT1512 & TFT1812:
Insert the three interconnecting blocks between the four centre
planks.
Position interconnecting blocks in the centre of the tray.
For TFT2014:
Insert the four interconnecting blocks between the five centre
planks.
Position interconnecting blocks in the centre of the tray.
4
Re-install the end plank and fasteners.
Tighten fasteners securely.
Read instructions thoroughly before commencing
installation.
Refer to Titan Tray instructions for tray assembly.
Skip to Step 5 on the following page if you have
already inserted the interconnecting blocks.
1
M5 x 10 BOLT
(92187)
x8
ANCHOR NUT
(22-0959)
x8
ALLEN KEY
(22-0055)
x1
M8 DROP-&-TURN
BOLT (22-0924)
x4
M8 T BOLT
(22-0961)
x8
