¥ _mv \qg
¥ Kmlgj \_~v_ x~gv\~kk_\
Refer to the indoor unit installation manual.
ËJ WUJ MR JU¢RUD M]J MJM UWE ¢RU JY\] GEQRRU WEGM °YXJ WUJ JY\] GEQRRU WEGM
operates properly following the installation manual attached to the unit.
¦¢ HRW JU¢RUD M]J MJM UWE ¢RU YNN GEQRRU WEGM YM RE\J0 HRW \YEERM QJMJ\M YEH
erroneous connection, if any, of the refrigerant pipes and the connecting wires.
* The compressor operation is not available for 3 minutes at least after the power
is supplied.
§]J \RDUJRU \YE JDGM ERGJ xWM Y¢MJU MWUE RE M]J R¤JU WNH RU GE \YJ
of low outside air temperature.
:~qv vp_ \_mvz\v |\~v_xvl_ _xpzglm
Once the compressor stops, the restart preventive device operates so the compressor
will not operate for 3 minutes to protect the air conditioner.
¥ Kmlgj 9¡ lg ~qv{~~\ qglv
~v_¢
8g xzm_ ~ vp_ v_mv \qg \~ ~qv{~~\ qglv zkk lg{~~\ qglvm ~|_\zv_ p_\_~\_
~q xzg g~v {_v_xv zg _\\~g_~qm x~gg_xvl~g ~ \_\lj_\zgv |l|_m zg{ vp_
x~gg_xvlgj l\_m 8 lv zlm zv {_v_xvl~g ~ zg _\\~g_~qm x~gg_xvl~g _ mq\_
v~ xz\\ ~qv vp_ v_mv \qg \~ \_~v_ x~gv\~kk_\ lvp \__\_gx_ v~ ¥ Kmlgj
\_~v_ x~gv\~kk_\
£·Ðª
½¥
Cooling operation
£·Ð³
OFF
£·Ðª
½¥
Heating operation
£·Ð³
½¥
¼ ¡¢MJU JU¢RUDGE M]J MJM UWE0 JM £·Ðª MR ½¾¾
¡ ¢J¤ J\REQ Y¢MJU M]J \RDUJRU MYUM0 Y \NYEGE ERGJ DYH `J ]JYUQ ¢URD
the inside of the outdoor unit. The noise is coming from the check valve due to the
small difference in pressure in the pipes. The unit is not faulty.
p_ v_mv \qg ~|_\zvl~g ~{_ xzgg~v _ xpzgj_{ =8? mlvxp 9¡ {q\lgj
vp_ v_mv \qg +~ xpzgj_ vp_ v_mv \qg ~|_\zvl~g ~{_ {q\lgj vp_ v_mv \qg mv~|
vp_ v_mv \qg =8? mlvxp 9¡ :v_\ xpzgjlgj vp_ v_mv \qg ~|_\zvl~g ~{_
\_mq_ vp_ v_mv \qg mlvxp 9¡ /
¥ _mv \qg
¥ X_~\_ v_mv \qg
:v_\ x~|k_vlgj lgmvzkkzvl~g zg{ vp_ l\lgj zg{ |l|lgj ~ vp_ lg{~~\ zg{
~qv{~~\ qglvm xp_x] ~\ \_\lj_\zgv k_z]zj_ k~~m_g_mm lg vp_ |~_\ mq||k
~\ x~gv\~k l\lgj \~gj |~kz\lv zg{ g~ {lmx~gg_xvl~g ~ ~g_ |pzm_ lg vp_
mq||k
Km_ z ¦ ~kv ~p v_mv_\ v~ xp_x] vpzv vp_ \_mlmvzgx_ _v__g vp_ |~_\
mq||k v_\lgzkm zg{ j\~qg{ lm zv k_zmv ¬
=~ g~v xz\\ ~qv vplm v_mv ~g vp_ x~gv\~k l\lgj +k~ ~kvzj_ xl\xqlv/ v_\lgzkm
Warning:
=~ g~v qm_ vp_ zl\ x~g{lvl~g_\ l vp_ lgmqkzvl~g \_mlmvzgx_ lm k_mm vpzg ¬
8gmqkzvl~g \_mlmvzgx_
After installation or after the power source to the unit has been cut for an extended
JUGRQ0 M]J GEWNYMGRE UJGMYE\J ¤GNN QUR `JNR¤ ª °è QWJ MR UJ¢UGJUYEM Y\\WDWNYM-
ing in the compressor. This is not a malfunction. Perform the following procedures.
1. Remove the wires from the compressor and measure the insulation resistance of
the compressor.
³ ¦¢ M]J GEWNYMGRE UJGMYE\J G `JNR¤ ª °è0 M]J \RDUJRU G ¢YWNMH RU M]J UJGMYE\J
dropped due the accumulation of refrigerant in the compressor.
3. After connecting the wires to the compressor, the compressor will start to warm
up after power is supplied. After supplying power for the times indicated below,
measure the insulation resistance again.
§]J GEWNYMGRE UJGMYE\J QUR QWJ MR Y\\WDWNYMGRE R¢ UJ¢UGJUYEM GE M]J \RD-
UJRU §]J UJGMYE\J ¤GNN UGJ Y`ROJ ª °è Y¢MJU M]J \RDUJRU G ¤YUDJQ
up for four hours.
(The time necessary to warm up the compressor varies according to atmospheric
conditions and refrigerant accumulation.)
§R RJUYMJ M]J \RDUJRU ¤GM] UJ¢UGJUYEM Y\\WDWNYMJQ GE M]J \RDUJRU0 M]J
compressor must be warmed up at least 12 hours to prevent breakdown.
¬ ¦¢ M]J GEWNYMGRE UJGMYE\J UGJ Y`ROJ ª °è0 M]J \RDUJRU G ERM ¢YWNMH
zqvl~g¢
p_ x~|\_mm~\ lkk g~v ~|_\zv_ qgk_mm vp_ |~_\ mq||k |pzm_ x~gg_xvl~g
lm x~\\_xv
q\g ~g vp_ |~_\ zv k_zmv p~q\m _~\_ mvz\vlgj ~|_\zvl~g
- Starting operation immediately after turning on the main power switch can result
in severe damage to internal parts. Keep the power switch turned on during the
operational season.
p_ ~kk~lgjm qmv _ xp_x]_{ zm _kk
§]J RWMQRRU WEGM G ERM ¢YWNMH ÁCÇ RE M]J \REMURN `RYUQ R¢ M]J RWMQRRU WEGM Y]
when the outdoor unit is faulty.
ËRM] M]J Y YEQ NGÖWGQ MR OYNOJ YUJ \RDNJMJNH RJE
¥¡ _\lj_\zgv x~kk?q| {~g/
Perform the following procedures to collect the refrigerant when moving the indoor
unit or the outdoor unit.
1
Turn off the circuit breaker.
2
Connect the low pressure side of the gauge manifold to the service port of the
gas side stop valve.
3
Close the liquid stop valve.
4
Supply power (circuit breaker).
* Start-up of the indoor-outdoor communication takes about 3 minutes after the
power (circuit breaker) is turned on. Start the pump-down operation 3 to 4 minutes
Y¢MJU M]J R¤JU ®\GU\WGM `UJYXJU´ G MWUEJQ ½¥
5
ºRE©UD M]YM £·Ð³ G JM MR ½¾¾0 YEQ M]JE JM £·Ðª MR ½¥ MR JU¢RUD M]J MJM
run for cooling operation. The compressor (outdoor unit) and ventilators (indoor
and outdoor units) start operating and test run for cooling operation begins.
Immediately after performing the test run for cooling operation, set the outdoor
JUOG\J ¤GM\] £·³¬ ®WD QR¤E ¤GM\]´ ¢URD ½¾¾ MR ½¥
¼ ÇR ERM \REMGEWJ MR RJUYMJ ¢RU Y NRE MGDJ ¤GM] M]J ¤GM\] £·³¬ JM MR ½¥ °YXJ
sure to switch it to OFF after pump down is completed.
6
Fully close the gas stop valve when the pressure reading on the gauge drops
0.05 - 0.00 MPa (approximately 0.5 - 0.0 kgf/cm
2
)
7
£JM £·Ðª MR ½¾¾ MR MR M]J YGU \REQGMGREJU RJUYMGRE ®£JM M]J RWMQRRU JUOG\J
¤GM\] £·³¬ ¢URD ½¥ MR ½¾¾´
8
Turn off the power supply (circuit breaker).
* If too much refrigerant has been added to the air conditioner system, the pressure
may not drop to 0.5 kgf/cm
2
. If this occurs, use a refrigerant collecting device
to collect all of the refrigerant in the system, and then recharge the system with
the correct amount of refrigerant after the indoor and outdoor units have been
relocated.
Warning:
p_g |q|lgj {~g vp_ \_\lj_\zgv mv~| vp_ x~|\_mm~\ _~\_ {lmx~gg_xv-
lgj vp_ \_\lj_\zgv |l|_m p_ x~|\_mm~\ z q\mv zg{ xzqm_ lgq\ l zg
~\_ljg mqmvzgx_ mqxp zm zl\ _gv_\m vp_ mmv_
