MIMAKI UJF-605C, Руководство по эксплуатации

Страница: 14 / 154

- xii -
Power supply and voltage
• This unit contains parts applied high
voltage. Carrying out electrical work
by those unauthorized for that work is
prohibited.
• To prevent electrical shock, be sure
to set OFF the main power circuit
breaker and disconnect the power
plug before carrying out maintenance.
For some units, capacitors may take
one minute for discharging; therefore,
start maintenance work three minutes
after setting OFF the main power
circuit breaker and disconnecting the
power plug.
• The main power circuit breaker
should be set ON only by personnel
with sufficient knowledge about
operations of this unit.
• Be sure to carry out grounding work
to prevent electrical shock.
• Use the unit under the power
specifications given.
Be sure to connect the power cable
plug to a convenient outlet grounded,
or fire or electric shock might occur.
Handling of UV lamp
• The UV lamp is made of glass and
should not be dropped, hit against
anything, given excessive force or
scratched, or it may cause damage to
the UV lamp.
• Do not use the UV lamp in an
ambience with a possibility of
catching fire (gasoline, combustible
gas spray, thinner, lacquer, powder
dust, etc.). In addition, do not put
paper or cloth near or on the UV
lamp, or it may cause fire.
• Do not break a used UV lamp; put it
in a container and discard likewise
ordinary fluorescent lamps according
to the local regulations. Breaking a
UV lamp will cause glass fragments to
be scattered.
• In rare cases, the UV lamp may
break. We recommend you to
replace the UV lamp with a new one
before it reaches its rated life.
• Be sure to use only the UV lamp
recommended by Mimaki, or it may
cause fire or damages to the unit.
Never use UV lamps other than
those recommended by Mimaki. We
would take no responsibility for any
troubles caused through the use of a
UV lamp not recommended by
Mimaki.
• Never look at the UV lamp being lit
with your naked eyes, or it may
cause pain in your eyes or visual
impairment. Be sure to wear safety
glasses.
• Do not apply ultraviolet (UV) light
directly to your skin, or it may cause
irritation on your skin.
• Do not touch the lamp on or right
after the lamp off with bare hands to
avoid from burn injury. Make sure to
replace the lamp after it cools down
completely.
• Before replacing, mounting or
demounting a lamp, be sure to set
the power OFF, or it may cause
electrical shock.
Handling of the power cable
• Use the supplied power cable.
• Take care not to damage, break or
work on the power cable. If a heavy
matter is placed on the power cable,
heated or drawn, the power cable
can break to cause fire or electric
shocks.
WARNING