MIMAKI UJF-605C, Руководство по эксплуатации

Страница: 37 / 154

- 1-17 -
Types of media that can be used
The following describes the sizes of media that can be used and the method of handling.
Sizes of media that can be used
Maximum 700 mm
Minimum 600 mm
Max. printing width 600 mm
Max. printing length 500 mm
Thickness 50 mm or less
Weight 5kg or less
Precautions in handling the media
Carefully observe the following when handling the media.
• Expansion and contraction of the media
Do not use sheet types of media immediately after unpacking.
The media can expand and contract due to room temperature and humid-
ity.
The media have to be left in the atmosphere in which they are to be used
for 30 minutes or more after unpacked.
• Curling of media
Tabular media should be flat or curled downward (swelled at the center)
with the printing surface facing up. Media curled upward may not be ab-
sorbed to the table.
When storing media that is easily curled, place them on a base or pallet
slightly smaller than the media area so that the media will be curled down-
ward during storage.
• When using the table
In order to maintain the absorption effect, block the absorption holes on the
table, which cannot be covered with media, with other media thinner than
those to be used. ( P.2-7)
• Other notices
* Do not put anything on coated paper, or discoloration may occur.
* This unit is of the movable-table type. Curled media not wholly ab-
sorbed or those that will go out of alignment during table movement
cannot be used. They may be made available when they are fixed on
the table with adhesive tape, etc.