MIMAKI UJF-605C, Руководство по эксплуатации

Страница: 141 / 154

- 6-7 -
Error message Cause Corrective measure
ERROR 35
MARK DETECT
No registration mark detected.
(During copy-printing operation)
1. Check whether or not the sheet
is curling up.
2. Confirm the appropriate detect
starting point specified.
3. Confirm the black registration
mark printed against the white
back-ground.
4. Confirm no dust or dirt in be-
tween the registration marks.
In case setting value of [DIST.
REVI.] is [BEFORE], confirm no
mistake on the specified length.
5. Confirm no mistake on the
registration mark settings.
6. Confirm the status and the
settings described above. If still
no registration mark detected,
contact your distributor or us.
ERROR 36
HEAD GAP
The gap between the head and
media is too narrow. Adjust the head gap again.
ERROR 34
DATA REMAIN
ERROR 30
OPERATION
ERROR 24
I / F INITIAL
ERROR 23
HOST I / F
ERROR 20
I / F BOARD
Settings for functions have been
tried to be changed though there
remains received data that has not
yet been printed.
An error occurs on the interface
between the I/F board and the
control board.
Initial operation failure of the I/F
board and control board.
HOST I/F Timeout error has arisen
during communication between the
host computer and interface board.
Improper operation has been
conducted on the operation panel.
Print all pieces of received data or
execute the data clear function.
Then, change the settings.
Perform a proper operation.
Turn off the power to the device and
turn it on after a while. If the same
error message appears again on the
LCD, contact your local distributor to
call for service.
Check to be sure that the cable is
securely connected to the host
computer and interface board. Also,
check to ascertain that no error has
arisen on the host computer side.
Turn off the power to the device and
turn it on after a while. If the same
error message appears again on the
LCD, contact your local distributor to
call for service.