MIMAKI UJF-605C, Руководство по эксплуатации

Страница: 96 / 154

- 4-8 -
Setting the operation of the registration mark detection
[MARK SENSOR]
Before detecting registration marks, make settings necessary for detection.
In addition, check the response of the Mark sensor. Registration marks are detected when
printing. ( P.2-21)
Set the operation of the registration mark detection [MARK SETUP]
This function is used to automatically detect a registration mark.
Correct the inclination of the sheet loaded on the device, origin of printing and distance
between registration marks. Printing on printed media is enabled by compensating the
inclination of the set sheet and the printing origin.
The following types of the registration marks are to be read.
• The initial setting for [DETECT] operation is OFF. Therefore, no messages
are indicated when printing.
• Once the device detects marks, the origin is established at the location of
MARK1. If you establish another origin at a different location using the jog
key (arrow key), the origin is rendered effective.
Registration mark condition
Printed registration mark is required to fulfill all the following conditions.
* The registration mark length must be 4 - 40mm on a side.
* The line width of mark shall be equal to or more than 0.3 mm and equal to
or less than 0.5 mm.
* To detect the registration marks, no stain or print image should be in
between the marks.
Mark1 Mark2
Mark Form : TYPE2
Mark Form : TYPE1