MIMAKI UJF-605C, Руководство по эксплуатации

Страница: 61 / 154

- 2-23 -
Printing repeatedly (COPY)
Data (1 edition) printed immediately before is printed again.
This operation can be carried out from the operation panel or sub-panel in the same way.
• If the temperature in the water heater or in the UV device has not reached
the predetermined value, a message is indicated. In this case, printing is
disabled. It is enabled when the error indication has disappeared.
STEPS:
1. After printing data, enter the LOCAL
mode.
Make sure to set the media and turn the vacuum
switch on.
2. Press the [COPY] key.
The number of drawn copies is displayed.
• If there is no data drawn right before
it, the message below is displayed
and you cannot draw a copy.
3. Press the [ENTER] key.
Printing condition and the number of copies that is
being drawn are displayed alternately.
• When using the sub-panel, pressing
the ENTER key is not required.
• Adjust the head gap when Sense
mode has been set. See the descrip-
tion of gap check (
P.2-13).
• When registration mark detection has been set, the registration
marks are detected in the same procedure as registration mark
checking. For details, see Chapter 4.
(
P.4-8). When registration mark detection is not necessary,
press the [END] key. <REMOTE> screen is restored.
4. The local mode is restored after printing
has completed.
Turn the vacuum switch OFF and remove media.
COPY
< COPY>
UV NOT READY
<COPY>
WATER NOT READY
<<LOCAL>>
<<LOCAL>>
< REMOTE > 600X 600
HOST / 4P
COPY CNT: 1
<ENT>
Displays
alternately.
<COPY> CNT: 2
COPY
NO DATA
The number of drawn copies
The number of copies
that is being drawn