MIMAKI UJF-605C, Руководство по эксплуатации

Страница: 45 / 154

- 2-7 -
Setting the media
All absorption holes on the table may not be blocked with media of a certain size. If neces-
sary, block such absorption holes with a sheet such as paper, film, etc. thinner than the
media used. If the media is likely to go out of alignment, affecting the printing, additionally
fix the media with adhesive tape.
Types of media that can be used
Only media which meet the following conditions are available:
Size : 600mm x 500mm
Thickness : 50mm or less
• Only media with thickness of up to 50 mm are available. Use of media with
thickness exceeding 50 mm will give damages to the cover.
• Adhesive tape, when used, must be of the kind that leaves no adhesive
materials or tape itself on the table.
• Do not use curled media, or normal printing will be disabled.
• Do not use media larger than the table area.
• In case printing on a heavy media, do not put it on the front side. Put the
media on the middle of the table to avoid a inclined table by the weight.
• Do not place hands on the UV light-resistant panel, or the table is inclined
and it may stop printing.
Front UV light-resistant curtain
When media of a certain height is set, light from the UV lamp may be leaked. To prevent
leakage of light, attach the supplied front UV light-resistant curtains on the front cover. In
this case, note that the lower end of the curtain should not touch the table surface.
Small
Large