MIMAKI UJF-605C, Руководство по эксплуатации

Страница: 18 / 154

- xvi -
Precautions in installation
CAUTION
A place exposed to direct sunlight
• Do not install the device at a place
where the temperature of the cut
panel surface exceeds 60 ° C (140 ° F).
The cut panel can deform or break
down.
A place in which temperature and humidity
vary by a great margin
• Use the device under the
following environment. Operating
environment: 15 to 30 ° C (59 to 86 ° F)
35 to 65% (Rh)
A place exposed to direct air blow from air
conditioner, etc.
• Do not install the device to direct are
blow from air conditioner, etc, or the
ink may get spattered.
A place that is not horizontal
• If the printer is not leveled, the
printer will fail to give correct results.
Also the tilted printer can break.
A place that vibrates
• The device will fail to give correct
results if installed in a place that
vibrates.
A place where fire is present
• The printer is a precision machine.
Do not use it in a place that is filled
with dirt and dust.
CAUTION
Notes on UV lamp
• The UV lamp performance and service life are significantly affected by the UV irradiation
and UV power supply units used. Never use those UV devices other than those
recommended by Mimaki. We would take no responsibility for any troubles caused through
the use of a UV devices not recommended by Mimaki.
• When handling the UV lamp or the silica glass on the bottom of the irradiation device, be
sure to wear the gloves attached and never touch them with bare hands, or the UV ink
curing level is significantly lowered. If the UV lamp or silica glass is contaminated, wipe it
with clean gauze moistened with alcohol. (Do not use alcohol for cleaning the exterior
cover, or the paint will peel off.)
• Securely mount the UV lamp to the socket, or the lamp may be dropped or overheated.