Magnetic Autocontrol MHTM MicroDrive, Руководство по эксплуатации

Страница: 125 / 196

Barrier MHTM
TM
MicroDrive
Parameterising control unit
5815,5001US / Version 02.66 125
Operating view

Main menu

Setup

Delays
Parameters Description
Close delay The barrier only closes if the set time for the closing delay is over. The timer for
closing delay is started with the closing signal. With this parameter, you can
also set the "Lead time" in the "Signal light" menu.
Setting range
 0 to 15 s
Factory setting
 0 s
Light barrier delay
The barrier only closes if the set time for the light barrier delay is over. The
timer for light barrier delay is started with clearance of the light barrier.
Setting range
 0 to 15 s
Factory setting
 5 s
Impact delay After the control unit has recognized that, e.g., a vehicle roof was hit by the
closing barrier arm, the control unit tries to close the barrier again after the set
impact delay. Impact is possible if, e.g., a user tries to drive through the barrier
without permission.
The following conditions must be met for the barrier to close after the end of
the impact delay:
 In the "Impact Settings" menu, the parameter "Automatic closing" must be
set to "Automatic".

The safety devices, such as safety loop or safety light barrier, must be
clear.

Also see page 130, chapter 10.10.7, menu "Impact settings".
Setting range
 5 to 30 s
Factory setting
 5 s
Table 43: Menu "Delays"