Magnetic Autocontrol MHTM MicroDrive, Руководство по эксплуатации

Страница: 128 / 196

Barrier MHTM
TM
MicroDrive
Parameterising control unit
128 5815,5001US / Version 02.66
Drive direction 1: "Safety loop

Opening loop"
Mag00096
1 2
3 4
5
Fig. 49: Program mode 5 with vend count,
Passage in direction 1
1 Remote control, card reader, coin accepter, etc.
2 Barrier
3 Opening
loop
4 Safety loop
5 Passage in direction 1
The barrier is opened from direction 1 "Safety loop

Opening
loop" with a pulse at the "Opening with vend count" pulse, e.g. with
a card reader or coin accepter. At the same time, an internal vend
count is incremented.
After passage of the safety loop and the opening loop, the vend
Count is decremented again. When the internal vend count
reaches the value "0”, the barrier is closed.
Additionally, the vend count is set to the value "0" and the barrier
closed in the following cases, depending on the settings for the
"Vend count" parameter:
 The vehicle does not drive over the supervision facility within
the set hold-open time.
 A closing signal is assigned.
The barrier closes in the following cases:
 If the vehicle drives over both loops in direction 1, the barrier
closes as soon as the vehicle leaves the opening loop. The
opening loop here acts as an extended safety loop.
 If a vehicle drives onto the safety loop but leaves it again
backwards, the hold-open time is deleted and the barrier
closes.
 If the vehicle drives over neither of the two loops, i.e. there is no
drive through, the barrier closes depending on setting of the
"vend count" parameter.