Magnetic Autocontrol MHTM MicroDrive, Руководство по эксплуатации

Страница: 165 / 196

Barrier MHTM
TM
MicroDrive
Malfunctions
5815,5001US / Version 02.66 165
13.3.2 Warning and interference messages – Motor GW
Number Description Possible cause Corrective action
2220
WARNING Overcurrent Overcurrent was recognised

Warning may appear in
connection with impact.
 If no impact took place,
check the cables.

Contact service if required.
3211
WARNING Overvoltage Overvoltage was recognised  Warning may appear in
connection with impact.
 If no impact took place,
check the cables.
 Contact service if required.
3221
WARNING Undervoltage Undervoltage was recognised  Warning may appear in
connection with impact.

If no impact took place,
check the cables.
 Contact service if required.
4210
WARNING Overtemperature A high temperature was
recognised.  Check motor temperature
via display. The temperature
must be below 100 °C.

See page 142,
chapter 10.14.
 Contact service if required.
4220
WARNING Derating error Motor power intake is reduced
to avoid further temperature
increase.  Remove impermissible
attachments
 Check the spring setting of
the balancing springs.
 Reduce speed of the barrier
arm.
 Contact service if required.
FF30
WARNING Impact detection Impact was recognised.  Check safety devices.
 Adjust menu "Cut off angle"

See page 126, chapter
10.10.3.
 If there was no impact on an
obstacle/vehicle, check the
spring settings of the
balancing springs and
mechanics.
7510
ERROR Motor
communications
error Communication between motor
and control impaired or
interrupted  Verify cables
 Contact service if required.
FF32
ERROR HW-Enable-Test
failed – Contact service.
FF33
ERROR LS-Test failed Safety light barrier test failed Check light barrier and light
barrier connection.