Magnetic Autocontrol MHTM MicroDrive, Руководство по эксплуатации

Страница: 80 / 196

Barrier MHTM
TM
MicroDrive
Assembly and installation
80 5815,5001US / Version 02.66
10. Unhook the balancing springs in the lever system. For this,
press a tool straight through the upper tool bore. The lever
arm is pressed from the upper dead point.

See page 168,
chapter 13.5.
11. Remove the flange shaft cover disc of the barrier housing.
Push a long rod through the flange shaft for this and slightly
push it against the cover.
12. Push the flange shaft to the other side by turning. The flange
shaft must be flush with the counter bearing on the side where
the barrier is not mounted. The flange shaft points out of the
barrier housing by approx. 2.44 in (62 mm) on the other side.
13. Tighten the two hexagon socket screws of the clamping lever
at the flange shaft.
 Use a torque wrench with hexagon socket: 10 AF
 Tightening torque: 88.508 lbf ft (120 Nm)
14. Hook in the balancing springs in the lever system.
15. Slip the v-ring over the flange shaft. The sealing lip points
towards the barrier housing.

See also page 79, Fig. 33.
16. Remove flange from the barrier arm. For this, loosen the 4
hexagon socket screws 5 AF at the barrier arm.
17. Attach the flange on the other side of the barrier arm. Observe
position of the two slot nuts. The shorter protrusion of the
flange must point towards the barrier arm end.

See also
page 74, Fig. 27.
 Use a torque wrench with hexagon socket: 5 AF
 Tightening torque: 11.801 lbf ft (16 Nm)
18. Push barrier arm with pre-assembled flange onto the flange
shaft.
19. Align barrier arm vertically.
20. Install the flange on the flange shaft using the 4 hexagon
socket screws. To tighten the screws evenly.

Use a torque wrench with hexagon socket: 10 AF
 Tightening torque: 55.318 lbf ft (75 Nm)
21. Close screws and threaded bores with the included grey
plastic covers.
22. Insert the cover disc for the flange shaft.
23. Push the barrier into the top-most position. The clamping lever
must be at the stop for the "open" position. If required, push
straight through the upper tool bore with a tool to press the
lever arm from the dead point.

See page 168, chapter 13.5.
24. Check the vertical alignment of the barrier arm with a level
and correct with the hexagon socket screws at the flange if
necessary.
25. Switch on power supply.