Magnetic Autocontrol MHTM MicroDrive, Руководство по эксплуатации

Страница: 144 / 196

Barrier MHTM
TM
MicroDrive
Parameterising control unit
144 5815,5001US / Version 02.66
Operating view

Main menu

Setup

Detector 1 (A-B)

Frequency settings
Parameters Description
Freq. A Displays the currently measured frequency for induction loop A
Freq. B Displays the currently measured frequency for induction loop B
Freq. Shift Interference influences, e.g. from external loop detectors or induction loops of
barriers close by can influence the frequency of loops A and B. Use the
parameter "Freq. Shift" to change the frequency values for loops A (channel A)
and B (channel B) by approx. 10 % and thus reduce the influence of loops A
and B.
Options for channels A and B.
 High: high frequency value

Low: low frequency value
Ref value A Displays the reference frequency for induction loop A
Ref value B Displays the reference frequency for induction loop B
Table 57: Menu "Frequency settings"
10.15.1 Check the working frequency of the induction loops.
1. The operating view is displayed.

See page 106, Fig. 44.
2. Press the left control button repeatedly, until the menu
"Detector 1 (A-B)" is displayed.
Mag00127a
f: 25454 Hz 38576 Hz
D
f/f: 0.003 % 2.565 %
A B
5 6
1
2 3
4
Detector 1 (A – B)
Fig. 51: Example "View – Menu Detector 1 (A-B)"
1 Relative frequency of induction loop A
2 Currently measured frequency of induction loop A
3 Currently measured frequency of induction loop B
4 Relative frequency of induction loop B
5 If another optional detector module is present:
Switching between the two detector modules
6 Recalibration of the induction loops
3. Use the right button to leave the "Detector 1 (A-B)" menu.
The operating view is displayed.