MacDon FlexDraper FD1 Series, Руководство оператора, Страница: 82 / 510

OPERATION
NOTE:
The following steps are only required if the above
has not worked.
3. Remove the linkage cover. Refer to
Removing Linkage
Covers, page 37
.
4. Retrieve the supplied torque wrench (A) that is stored
on the fl oat module frame on the right-hand side.
Figure 3.54: Torque Wrench
5. Place the torque wrench (A) on bolt (B) and use it to
move the wing until the lock engages.
6. Replace the torque wrench (A) and reinstall the
linkage cover. The wings will not move relative to the
header.
Figure 3.55: Header Wing
3.7.3 Checking and Adjusting Header Wing Balance
IMPORTANT:
Before proceeding, the header fl oat must be set properly. Refer to
Checking and Adjusting Header Float, page 56
.
The header wing balance allows the wings to react to
changing ground conditions. If set too light, the wings
will bounce or not follow ground contours, leaving uncut
crop. If set too heavy, the end of the header will dig into
the ground. After the header
fl oat has been set, the wings
must be balanced for the header to follow the ground
contours properly.
Figure 3.56: FlexDraper
®
Header
147831
64
Revision A