MacDon FlexDraper FD1 Series, Руководство оператора, Страница: 70 / 510

OPERATION
2. Support the wheel weight by lifting slightly with one
hand on handle (B), and pull up on the handle (A) to
release the lock.
3. Lift the wheel using handle (B), and engage the support
channel into the center slot (C) in the upper support.
4. Push down on the handle (A) to lock.
Figure 3.32: Stabilizer Wheel
5. Lower the header to the desired cutting height using
the combine controls and check the load indicator.
Figure 3.33: Load Indicator
IMPORTANT:
Continuous operation with excessive spring
compression (i.e., load indicator reading greater
than 4 or a compressed length less than
11-5/8 in. [295 mm]) (A) can result in damage to the
suspension system.
6. Adjust the header angle to the desired working angle
with the machine’s header angle controls. If header
angle is not critical, set it to mid-position.
7. Use the combine’s Auto Header Height Control
(AHHC) to automatically maintain cutting height. Refer
to
3.8 Auto Header Height Control (AHHC), page 99
and your combine operator’s manual for details.
NOTE:
The height sensor on the FM100 Float Module must
be connected to the combine height control system
in the cab.
Figure 3.34: Spring Compression
147831
52
Revision A