MacDon FlexDraper FD1 Series, Руководство оператора, Страница: 113 / 510

OPERATION
9. Pull at the tip of the crop divider and ensure there is
no lateral movement. If necessary, adjust bolts (A) to
tighten crop divider and eliminate lateral movement.
10. Close or install endshields. Refer to
3.2.3 Endshields,
page 31
.
Figure 3.114: Crop Divider
Installing Crop Dividers without Latch Option onto Header
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel and raise header. Refer to your combine operator’s manual for instructions.
2. Stop engine and remove key.
3. Engage safety props. Refer to your combine operator’s manual for instructions.
4. Open or remove endshields. Refer to
3.2.3 Endshields, page 31
.
5. Remove crop divider from storage location by lifting
crop divider to disengage lugs (A) at lower end
and then lowering it slightly to disengage pin (B)
from endsheet.
Figure 3.115: Stored Crop Divider
147831
95
Revision A