MacDon FlexDraper FD1 Series, Руководство оператора, Страница: 437 / 510

MAINTENANCE AND SERVICING
10. Install the endshield support (A) at the applicable tine
tube location at the cam end.
11. Reinstall the reel endshields. Refer to
5.13.6 Reel
Endshields, page 423
.
Figure 5.236: Cam End
Center Disc and Tail End Bushings
12. Position the bushing halves (B) on the tine tube with
the fl angeless end adjacent to the reel arm, and
position the lug in each bushing half into the hole in
the tine tube.
13. Slide the reel arm (A) onto the bushing (B) and position
against the disc at the original location.
14. Reinstall the previously removed fi ngers or tines. Refer
to the following procedures as necessary:
•
Removing Plastic Fingers, page 410
•
Removing Steel Fingers, page 409
Figure 5.237: Tail End
15. Install the bushing clamp (A) onto the tine tube adjacent
to the fl angeless end of the bushing (B).
16. Position the clamp (A) on the bushing (B) so the edges
of the clamp and bushing are fl ush when the clamp
is fi t into the groove on the bushing and the lock tabs
are engaged.
Figure 5.238: Bushing
147831
419
Revision A