MacDon FlexDraper FD1 Series, Руководство оператора, Страница: 435 / 510

MAINTENANCE AND SERVICING
NOTE:
Use a pair of modi fi ed channel lock pliers (A) to install
bushing clamps (C). Secure pliers in a vice and grind
a notch (B) into the end of each arm to
fi t the clamp
as shown.
Figure 5.230: Modified Pliers
Cam End Bushings
1. Position the bushing halves (B) on the tine tube with
the fl angeless end adjacent to the reel arm, and
position the lug in each bushing half into the hole in
the tine tube.
2. Slide the tine tube (A) towards the tail end of the reel to
insert the bushing (B) into the reel arm. If the tine tube
supports are installed, ensure the bushings at those
locations slide into the support.
3. Reinstall the previously removed fi ngers or tines. Refer
to the following procedures as necessary:
•
Removing Plastic Fingers, page 410
•
Removing Steel Fingers, page 409
Figure 5.231: Cam End
4. Install the bushing clamp (A) onto the tine tube adjacent
to the fl angeless end of the bushing (B).
5. Position the clamp (A) on the bushing (B) so the edges
of the clamp and bushing are fl ush when the clamp
is fi t into the groove on the bushing and the lock tabs
are engaged.
Figure 5.232: Bushing
147831
417
Revision A