MacDon FlexDraper FD1 Series, Руководство оператора, Страница: 111 / 510

OPERATION
5. Lift crop divider off endsheet and store as follows:
a. Insert pin (A) on crop divider into hole in endsheet
at location shown.
b. Lift crop divider and position lugs (B) on crop
divider into bracket on endsheet. Ensure lugs
engage bracket.
6. Close or install endshields. Refer to
3.2.3 Endshields,
page 31
.
Figure 3.110: Stored Crop Divider
Removing Crop Dividers without Latch Option from Header
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel and raise header. Refer to your combine operator’s manual for instructions.
2. Stop engine and remove key.
3. Engage safety props. Refer to your combine operator’s manual for instructions.
4. Open or remove endshields. Refer to
3.2.3 Endshields, page 31
.
5. Remove bolt (A), lock washer, and fl at washer.
6. Lower crop divider (B) and then lift to remove
from endsheet.
7. Close or install endshields. Refer to
3.2.3 Endshields,
page 31
.
Figure 3.111: Crop Divider
Installing Crop Dividers with Latch Option onto Header
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel and raise header. Refer to your combine operator’s manual for instructions.
2. Stop engine and remove key.
3. Engage safety props. Refer to your combine operator’s manual for instructions.
147831
93
Revision A