MacDon FlexDraper FD1 Series, Руководство оператора, Страница: 406 / 510

MAINTENANCE AND SERVICING
8. Check the draper seal between the drapers and the
cutterbar. Ensure there is a 0.04–0.08 in. (1–2 mm)
gap (A) between the cutterbar (C) and the draper (B).
9. Refer to
5.12.5 Adjusting Deck Height, page 391
to
achieve the proper gap.
Figure 5.164: Draper Seal
10. Adjust the backsheet de fl ector (A) (if required) by
loosening nut (D) and moving the de fl ector until there
is a 1/32–5/16 in. (1–7 mm) gap (C) between the
draper (B) and the de
fl ector.
11. Operate the drapers with the engine at idle so the talc
or talc/graphite lubricant makes contact and adheres
to the draper seal surfaces.
Figure 5.165: Draper Seal
5.12.3 Adjusting Draper Tension
WARNING
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under machine for any reason.
NOTE:
The drapers are tensioned at the factory and rarely need adjustment. If adjustment is required, tension the
drapers just enough to prevent slipping and to keep the draper from sagging below the cutterbar.
147831
388
Revision A