MacDon FlexDraper FD1 Series, Руководство оператора, Страница: 260 / 510

HEADER ATTACHMENT/DETACHMENT
10. With fl ighting on desired position, mark holes (A) and
drill 7/16 in. (11 mm) holes on auger tube.
11. Remove nearest access cover(s). Retain for
reinstallation.
12. Secure bolt-on fl ighting on the newly drilled holes (A)
using four fl ange head bolts (MD #152655) and
nuts (MD #135799).
13. Repeat Steps
1., page 241
to
12., page 242
for the
other fl ighting on the left-hand side.
Figure 4.43: Flighting on LH Side of Auger
14. Place fl ighting (MD #213361) (A) outboard of the
existing fl ighting (B) on the right-hand side of the
auger, as shown.
Figure 4.44: Flighting on RH Side of Auger
15. Repeat Steps
2., page 241
to
12., page 242
at the
right-side of the auger.
16. Torque all nuts to 35 ft · lbf (47 N · m) to eliminate
de fl ection on fl ighting, then torque all nuts and bolts
on fl ighting to 43–47 ft · lbf (58–64 N · m).
NOTE:
Ideally, the fl ighting should fi t tightly against the
auger tube; however, gaps are not uncommon.
Crop material may collect in this gap, but generally,
this will not affect performance. If desired, silicone
sealant may be used to
fi ll these gaps.
17. Add or remove fi ngers as necessary to optimize
feeding for your combine and crop conditions. Refer to
Installing Feed Auger Fingers, page 341
or
Removing
Feed Auger Fingers, page 340
.
18. If not adding or removing fi ngers, reinstall all access
covers and secure with bolts. Coat bolts with Loctite
®
#243 (or equivalent) and torque to 75 in·lbf (8.5 N·m).
147831
242
Revision A