MacDon FlexDraper FD1 Series, Руководство оператора, Страница: 410 / 510

MAINTENANCE AND SERVICING
1. Shut down the combine, and remove the key from
the ignition.
2. Check the deck height and ensure the draper (B) runs
just below the cutterbar (C) with a gap (A) of 1/8 in.
(3 mm) between the top of the deck front track and
the cutterbar.
NOTE:
Measurement is at the supports with the header
in working position and the decks fully forward.
Figure 5.173: Draper Seal
3. Loosen the draper tension. Refer to
5.12.3 Adjusting
Draper Tension, page 388
.
4. Lift the front edge of the draper (A) past the
cutterbar (B) to expose the deck support.
5. Measure and note the thickness of the draper belt.
Figure 5.174: Draper Adjustment
6. Loosen the two lock nuts (A) on the deck support (B)
one-half turn only
.
NOTE:
The number of deck supports (B) is determined
by the header size: four on single reels, and
eight on double reels.
7. Tap the deck (C) to lower the deck relative to the deck
supports. Tap the deck support (B) using a punch to
raise the deck relative to the deck supports.
Figure 5.175: Deck Support
147831
392
Revision A