Lenovo System x3250 M5, Инструкция по установке и обслуживанию

Страница: 562 / 740

4. If PFA re-occurs on the same DIMM connector, swap the other DIMMs on the same memory
channel one at a time to a different memory channel or Processor. (check service information for
this product/Install guide for population requirements for sparing/paring modes). If PFA follows a
moved DIMM to any DIMM connector on the different memory channel, replace the moved DIMM.
5. Check IBM Support website for an applicable Service Bulletins (Service bulletins) that applies
to this memory error. (Link to IBM support service bulletins)
6. (Trained service technician only) If problem continues to re-occur on the same DIMM connector,
inspect DIMM connector for foreign material and remove, if found. If connector is damaged,
replace system board.
7. (Trained service technician only) Remove affected Processor and inspect Processor socket pins
for damaged or mis-aligned pins. If damage is found or Processor is an upgrade part, replace
system board.
8. (Trained service technician only) Replace affected processor.
9. (Trained service technician only) Replace system board.
• W.68002 [W.68002] A CMOS battery error has been detected
Explanation: CMOS Battery Fault
Severity
Warning
User Response
Complete the following steps:
1. If the system was recently Installed, Moved, or Serviced, makesure the batter is properly seated.
2. Check IBM Support website for an applicable service bulletin or firmware update that applies to
this error.
3. Replace CMOS Battery
4. (Trained service technician only) Replace the system board.
548
Lenovo System x3250 M5Installation and Service Guide