Lenovo Flex System Fabric CN4093, Инструкция по применению

Страница: 67 / 634

© Copyright Lenovo 2017 Chapter 2: Initial Setup
67
Setup Part 4: IP Configuration
The system prompts for IPv4 parameters.
Although the switch supports both IPv4 and IPv6 networks, the Setup utility
permits only IPv4 configuration. For IPv6 configuration, see “Internet Protocol
Version 6” on page 403 .
IP Interfaces
IP interfaces are used for defining the networks to which the switch belongs.
Up to 128 IP interfaces can be configured on the CN4093 10 Gb Converged Scalable
Switch (CN4093). The IP address assigned to each IP interface provides the switch
with an IP presence on your network. No two IP interfaces can be on the same IP
network. The interfaces can be used for connecting to the switch for remote
configuration, and for routing between subnets and VLANs (if used).
Note:
Interfaces 125 ‐ 128 is reserved for IPv4 switch management.
1.
Select the IP interface to configure, or skip interface configuration at the prompt:
If you wish to configure individual IP interfaces, enter the number of the IP
interface you wish to configure. To skip IP interface configuration, press
<Enter>
without typing an interface number and go to “Default Gateways” on page 68 .
2.
For the specified IP interface, enter the IP address in IPv4 dotted decimal notation:
To keep the current setting, press
<Enter>
.
3.
At the prompt, enter the IPv4 subnet mask in dotted decimal notation:
To keep the current setting, press
<Enter>
.
4.
If configuring VLANs, specify a VLAN for the interface.
This prompt appears if you selected to configure VLANs back in Part 1:
Enter the number for the VLAN to which the interface belongs, or press
<Enter>
without specifying a VLAN number to accept the current setting.
IP Config:
IP interfaces:
Enter interface number: (1-128)
Current IP address: 0.0.0.0
Enter new IP address:
Current subnet mask: 0.0.0.0
Enter new subnet mask:
Current VLAN: 1
Enter new VLAN [1-4094]: