Lenovo Flex System Fabric CN4093, Инструкция по применению

Страница: 586 / 634

586
CN4093 Application Guide for ENOS 8.4
Creating a Policy Setting
The policy setting can be either secure (IOM is in secure mode) or legacy (IOM is in
legacy mode). In secure mode, only communication protocols that are deemed
secure can be used; most protocols that are not deemed secure are disabled. In
legacy mode setting, all protocols are allowed (LIOM behavior).
To display the current policy setting, enter:
Note:
Security policy can be applied only from CMM. You must reboot the IOM
for a new policy setting to be applied.
Protocols Affected by the Policy Setting
This section explains which protocols can and cannot operate in secure mode on
the CN4093 10 Gb Converged Scalable Switch.
Insecure Protocols
When you are in Secure Mode, the following protocols are deemed “insecure” and
are disabled:
 HTTP
 LDAP Client
 SNMPv1
 SNMPv2
 Telnet (server and client)
 FTP (server and client)
 Radius (client)
 TFTP Server
Except for the TFTP server, these protocols cannot be enabled when the switch is
operating in Secure Mode because the commands to enable or disable them are no
longer enabled.
The following protocols, although deemed “insecure,” are enabled by default and
can be disabled.
 DHCP client
 SysLog
Note:
Service Location Protocol (SLP) Discovery is also deemed “insecure” but is
unaffected by Secure Mode. SLP has the same default settings as in Legacy Mode.
If you can enable or disable SLP in Legacy Mode, you can enable or disable it the
same way in Secure Mode.
The following supported protocols are not enabled by default but can always be
enabled in Secure Mode.
 DNS Resolution
CN 4093(config)# show boot security-policy