Lenovo Flex System Fabric CN4093, Инструкция по применению

Страница: 50 / 634

50
CN4093 Application Guide for N/OS 8.4
5.
Enter
Q
to reboot the switch:
6.
After the reload is complete, log into the switch by using the default user
admin
with the default password
admin
.
7.
Enter configuration mode (config). Copy the active configuration to the running
configuration by using the
copy active-config running-config
admin-pw-bypass
command.
8.
Use the
show run
command to confirm the configuration is recovered. Set the new
admin and enable passwords. Save the running configuration to startup
configuration.
9.
Make sure the boot configuration ‐ block is active by using the
show boot
configuration-block
command. If it is not active, change the boot
configuration ‐ block with the following command:
Boot Management Menu
I - Change booting image
C - Change configuration block
R - Boot in recovery mode (xmodem download of images to recover
switch)
Q - Reboot
E - Exit
Please choose your menu option:
q
Resetting the board.
CN 4093> ena
Enable privilege granted.
CN 4093# configure terminal
Enter configuration commands, one per line. End with Ctrl/Z.
CN 4093(config)# copy active-config running-config admin-pw-bypass
Loading to current configuration.
CN 4093(config)# password
Changing admin password; validation required:
Enter current local admin password:
Enter new admin password (max 64 characters):
Re-enter new admin password:
New admin password accepted.
Password changed and applied, but not saved.
Notifying administrator to save changes.
CN 4093(config)# enable password ?
WORD The UNENCRYPTED (cleartext) 'enable' password
CN 4093(config)#
enable password admin1
CN 4093(config)# copy running-config startup-config
Confirm saving to FLASH (y/n) ? y
Copy running configuration to startup configuration
Switch is currently set to use factory default config block on next boot.
Do you want to change that to the active config block (y/n) ?
y
Next boot will use active config block.
CN 4093(config)# boot configuration-block active