Kverneland Exacta-TL-GEOSPREAD GS3, Руководство оператора

Страница: 18 / 171

Safety
18
Coupling shaft
Use the correct coupling shaft
Only use coupling shafts complying with the manufacturer’s
specification for that specific use! In order to ensure protection of both
man and machine exercise extreme caution when working at a
coupling shaft other then described in this manual and/or on the
instruction at the coupling shaft.
Modification of, and other special jobs on coupling shafts, require
written explicit order and procedure of both machine and coupling
shaft manufacturer is available! Use the correct tools and original
parts to ensure a good performance and maximum safety. The use of
an incorrect coupling shaft can cause damage to the machine.
Mount the appropriate protection
Externally accessible coupling shafts, the tractor's PTO shafts and
machine input-axle must be equipped with appropriate guards and
tubes. Working without guarding can cause serious or deadly injuries.
Replace protective coupling shaft tubes when required
Replace the coupling shaft protection sleeves at the first signs of wear.
Protection sleeves can wear without being noticed. Worn or damaged
protection sleeves can cause serious or deadly injuries.
Protect the PTO shaft end well
Slide the protection sleeve over the PTO shaft as soon as the coupling
shaft has been removed! Clothing could become entangled into an
unprotected PTO shaft end that could lead to serious injury.
Hydraulic system
Hydraulic oil is under high pressure
Never try to stop a leak with your fingers. Never try to locate a
hydraulic leak or try to contain it by hand! When inspecting always use
appropriate aid (e.g. a piece of wood or sheet metal) and wear safety
goggles, and gloves! High pressure fluid easily penetrates skin and
clothes, causing severe injuries. In the event of injury, contact your
physician immediately!
Electronic control system
Disconnect the control box
Disconnect the control box from the electric system as soon as no
more functions are needed in order to prevent unintentional operation.
Keeping the control box connected can be dangerous and can
damage the machine
as well as cause bodily injury.
Battery cables must be connected properly
Always disconnect the battery cable (negative pole) from the electric
system when working on the machine. Connect the battery cables
correctly: Positive pole first, followed by the negative pole. Always
equip the positive pole with the appropriate protective cap to avoid a
short circuit as this could lead to damage to the tractor and machine.
\