Use in the field
106
approaching headland with the GEOCONTROL function
switched off:
Close the dosing units by pressing the stop key before turning to
the headland. The PTO shaft can keep running if you intend to start
spreading immediately again.
You will find the correct procedure and corresponding distances on the
headland in
the next paragraph »Working method on the headland« and
paragraph »Spreading on field« from page 102.
Drive to the next tramline and re-start the spreader at the right time,
as displayed in the next paragraph »Working method on the
headland«.
In the event of spreader failure or stoppage:
Stop spreading immediately!
Disconnect the PTO shaft immediately!
See then paragraph »Failure and stoppage« on page 119.
I
NDICATION
If the hopper content becomes less than 220 lbs, the control system
switches off the automatic calibration. Measurement accuracy
declines in such a way that new automatic calibration cannot produce
a better discharge curve.
I
NDICATION
If the spreader is filled during the spreading process, e.g. from an
auger riding alongside the vehicle the automatic calibration must be
switched off. With automatic calibration the control system weighs the
dispersed quantity of fertilizer (lbs) within a certain time. It also checks
these values in terms of the selected, preset application rate. The
distributed quantity can therefore not be correctly weighed if the
hopper is filled while spreading. The weight in the hopper could even
increase during the measurement period. The correction performed
by the control system would be inaccurate as a result, which could
lead to crop damage.
Содержание Exacta-TL-GEOSPREAD GS3
Страница 6: ...Preface 6 ...
Страница 166: ...Notes 166 Notes ...