Baker D30R, User Manual

Page: 1 / 82

12/3/2009 | 71-022 V6
D30R 1
Users Manual
Digital Winding Tester
D30R
Baker Instrument Company, an SKF Group Company,
4812 McMurry Ave. Suite 100
Fort Collins, CO 80525
(970) 282-1200
(970) 282-1010 (FAX)
800-752-8272 (USA Only)
Note : This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference with the equipment is operated in its installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the product manual, may cause harmful interference to radio communications. If
this equipment does cause harmful interference, the user will be required to correct the
interference.
Due to the phenomena being observed and the material properties being measured, this
equipment does radiate radio frequency energy while in the active test mode. Care should be taken
to insure this radio frequency energy causes no harm to individuals or other nearby equipment.
Information furnished in this manual by Baker Instrument Company, an SKF Group Company,, is
believed to be accurate and reliable. However, Baker Instrument Company, an SKF Group
Company, assumes no responsibility for the use of such information or for any infringements of
patents or other rights of third parties that may result from its use. No license is granted by
implication or otherwise under any patent rights of Baker Instrument Company, an SKF Group
Company.
Warning:
Baker Instrument Company, an SKF Group Company, assumes no liability for damages consequent
to the use of this product. No part of this document may be reproduced in part or in full by any
means such as photocopying, photographs, electronic recording, videotaping, facsimile, etc.,
without written permission from Baker Instrument Company, an SKF Group Company, Fort Collins,
Colorado.