To be done before spreading
86
Testing the spreading
pattern of the border
spreading plate
When using the border spreading plate the aim is to obtain maximum
distribution to the border with minimum loss in the ditch.
This is then why the border spreading plate has to be tested. Do not
perform this test next to the ditch, rather mark a line behind which the
fictive ditch will be.
Operation
Switch the tractor off, remove the key from the ignition and engage
the parking brake of the tractor.
Disconnect the right spreading disc by sliding the connector to the
right. Secure the connector with a lock clip.
Attach the border spreading plate. We recommend that the border
spreading plate should be mounted with the triangle on the fixing
plate.
I
NDICATION
Check that the vanes do not touch the border spreading plate!
Set the spreader as per the details given in the spreading chart for
the selected working width that most closely matches the fertilizer,
seeds or granules and the instructions in paragraph »One-sided
boundary spreading with the border spreading plate«
(height of
the spreading disc = 75 cm/29.5 in above the troughs)
.
Place 1 trough in the middle of the tractor tracks. The centre of the
driving track must be 7 ft. from the line behind which the fictive ditch
is located.
Place 1 trough on the land next to the fictive border ditch and 2
troughs next to each other in the fictive ditch.
I
NDICATION
Position the troughs horizontally with a spirit level!
X
Y
Border spreading plate, position for a working
width of 65 -92 ft.
Connector
Содержание Exacta-TL-GEOSPREAD GS3
Страница 6: ...Preface 6 ...
Страница 166: ...Notes 166 Notes ...