Before first use
52
Shortening the coupling
shaft
The profiled tubes must overlap as far as possible, with a minimum of 5.91
in.
The profiled tubes must however have at least 25 mm/1 in. free clearance
at the outer edges when the tractor PTO shaft and the machine drive axle
are level.
Cut off the two profiled tubes to achieve the 25 mm/1 in. clearance.
Deburr both ends.
Clean the coupling shaft.
Shorten the protection sleeves by the same length.
Slide the coupling shaft halves into each other.
Connect the coupling shaft of the machine and the tractor.
Lift the machine with the power lift in the highest operating position.
\
WARNING
Put the machine on a supporting beam before moving in
between the tractor and machine
This will ensure that the machine cannot drop if the power lift
should inadvertently be operated while you are between the
tractor and machine. Switch also the tractor engine off and remove
the keys from the ignition. Without the support, a power lift that
drops could wedge you in, resulting in possible serious physical
injury.
The maximum operating angle of the coupling shaft is 30
°
when
lifted and 30
°
when lowered.This is the maximum length between
the PTO shaft and the machine drive axle.
Place the machine on a supporting beam with the power lift in
the highest position.
Switch the tractor off and remove the keys from the ignition.
Engage the parking brake of the tractor.
Check if the furthest working angle is less than 30
°
.
Check that the overlap of the profiled tubes is still at least 150
mm/5.91 in.
Remove the tractor section.
Apply grease to the profiled tubes.
Attach the protection sleeves.
Slide the coupling shaft halves into each other.
Mount the coupling shaft to the machine.
\
WARNING
Always mount the check chains of the protection sleeves
The check chains prevent the protection sleeves from rotating with
the coupling shaft. Crop or pieces of clothing can be wound
around rotating protection sleeves and cause material damage
and possibly severe physical injury.
Mount the check chains to both outer edges of the coupling
shaft protective sleeves.
Mount the other ends of the chains to a fixed point of the
tractor, respectively the machine.
max.30
o
max.30
o
max.30
o
max.30
o
Содержание Exacta-TL-GEOSPREAD GS3
Страница 6: ...Preface 6 ...
Страница 166: ...Notes 166 Notes ...