Krone BiG Pack 870 HDP XC, Оригинальная инструкция по эксплуатации

Страница: 26 / 410

2 Safety
2.4 Safety routines
26
BiG Pack 870 HDP XC
Original Operating Instructions 150000760_00_en
2.4.2 Securing raised machine and machine parts against lowering
WARNING
Crushing hazard due to movement of machine or machine parts
If the machine or machine parts are not secured against lowering, the machine or machine
parts may roll, fall or sag. Thus people could be squeezed or killed.
„ Lower the raised machine parts.
„
Shut down and safeguard the machine, refer to page 25 .
„ Before working on or under raised machine parts: Secure machine or machine parts
against lowering by means of hydraulic shut-off device (e.g. stop cock) on machine side.
„
Before working on or under raised machine parts: Safely support machine or machine
parts.
In order to safely support the machine or machine parts:
„ To support, only use suitable and sufficiently dimensioned materials that do not break or
yield.
„
Bricks and hollow blocks are not suitable for safely supporting the machine and machine
parts. Therefore they must not be used.
„
Car jacks are also not suitable for safely supporting the machine and machine parts. They
must not be used, as well.
2.4.3 Safely performing oil level check, oil change and filter element change
WARNING
Safely performing oil level check, oil change and filter element change
If oil level check, oil change and filter element change are not performed safely, the
operational safety of the machine may be affected. This can lead to accidents.
Safely perform oil level check, oil change and filter element change.
In order to perform oil level check, oil change and filter element change safely:
„ Lower raised machine parts or secure them against falling, refer to page 26 .
„
Shut down and safeguard the machine, refer to page 25 .
„
Observe the intervals to check the oil, change it and to change the filter element, refer to
page 236 .
„
Only use oil qualities/oil quantities mentioned in the consumables table, refer to page 58 .
„ Clean the area around the parts (for example gearbox, high-pressure filter) and make sure
that foreign bodies do not get into the parts or the hydraulic system.
„
Check existing seal rings for damage and replace them, if necessary.
„ Collect leaking oil or waste oil in a special container and dispose of it properly, refer to
page 21 .