Krone BiG Pack 870 HDP XC, Оригинальная инструкция по эксплуатации

Страница: 200 / 410

15 Settings
15.5 Setting MultiBale
200
BiG Pack 870 HDP XC
Original Operating Instructions 150000760_00_en
15.5 Setting MultiBale
Checking/setting position of the second needle yoke
BP000-172
In end position of the tying, the tube (2) of the second needle yoke (1) must be in the trough (3)
of the needle brake (4).
If the tube (2) is not in the trough (3):
ü
The upper dead point of the knotter needle is checked and set, refer to page 199 .
„
Check the upper dead point of the knotter needles and adjust it, if necessary refer to
page 199 .
ð
If the tube (2) of the second needle yoke (1) is not in the trough (3) of the needle brake
(4) after setting the knotter needles, the needle brake (4) must be shifted.
Shifting the needle brake
BP000-173
„ Shift the needle brake (4) lengthwise in the hole pattern (5) until the tube (2) of the needle
yoke (1) is situated directly in the trough (3) of the needle brake (4) when in end position of
the tying.
Checking the stop
„
Check the dimension X between the tube (2) of the needle yoke (1) and the stop (6).
ð If the dimension is X=13-20 mm , the setting is correct.
ð If the dimension is not X=13-20 mm , the stop (6) must be set.
Setting the stop
„ Position washers (7) under the stop (5) until dimension X=13-20 mm is reached.