Krone BiG Pack 870 HDP XC, Оригинальная инструкция по эксплуатации

Страница: 213 / 410

Settings 15
Setting the double knotter 15.17
BiG Pack 870 HDP XC
Original Operating Instructions 150000760_00_en 213
BPG000-040
ü The machine is shut down and safeguarded, refer to page 25 .
ü The knotter shaft is secured refer to page 92 .
The holding force is preset in the factory.
„ Loosen the counter nut (4).
„
Ensure stronger or weaker pre-tensioning of the twine retainer springs (3) via screw (2)
(approx. half a turn).
„ Tighten the counter nut (3).
15.17.5 Setting the blade lever
BPG000-041
The blade lever (1) must be aligned so that the billhook (3) can turn freely without touching the
blade lever.
However, the scraper comb (2) of the blade lever must slightly and evenly touch the back of the
knotter hook (3). In the blade lever dead-centre position, the distance between the scraper
comb of the blade lever and the billhook tip should be
X=15–18 mm . The blade lever has
reached the dead-centre position when the blade lever roll has reached the highest point on the
cam (4) in the knotter disc (5).
The areas of the blade lever that guide the twine (the marked area (I)) must be smoothed and
rounded to prevent the twine from tearing. The blade lever must be replaced when it is worn at
the marked area (formation of grooves).
ü The machine is shut down and safeguarded, refer to page 25 .
„
Trigger the tying process manually with machine at standstill, refer to page 110 .
„ Turn the flywheel manually in working direction until the blade lever roll has reached the
highest point on the cam (4) in the knotter disc (5),
refer to page 111 .
„
Apply the flywheel brake, refer to page 89 .
„ Check dimension X.
ð
If the dimension is X=15–18 mm , the setting is correct.