KROHNE optiplex 1300 c, Руководство пользователя

Страница: 31 / 95

Handbook OPTIFLEX 1300 C
31 OPTIFLEX 1300 C
9. Grease the thread (f) of the wiring compartment cover.
10. Screw on the wiring compartment cover (c). Remount cover lock (b).
11. Go to section 3.1: Commissioning, power-on and start-up before energizing the device to make sure
that the device is correctly installed and connected.
Wiring devices approved for use in potentially explosive atmospheres
Please refer to the special manuals included with the device (in print or on the CD-ROM supplied with the
device) for wiring devices for use in hazardous areas.
2.2 Power supply
2.2.1 General notes
Each output requires its own power supply.
Each output requires its own power supply.
Check that the device uses the correct power supply!
A supply voltage above the maximum value can cause irreparable damage to the signal converter.
Voltages above and below the specified limits can also lead to faulty measurements or to a device reset.
Refer to technical data in section 2.2.2: Power supply, non-Ex version. If the device is approved for use in
potentially explosive atmospheres, refer also to special manuals included with the device.
Power supply polarity
Observe the correct polarity for the device's electrical system!
The device will not function if the polarity is reversed!
Factors influencing supply voltage
Allow for voltage drop caused by the circuit load impedance (loop resistance).
This includes:
•
the cable
•
other devices in the circuit
•
resistors for connection of device tool managers and HART® controllers