Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 1324/1568
Destination IP Address value.
Destination L4 Port Keyword
- Specify the destination layer 4 port match conditions for the
selected extended IP ACL rule. The possible values are DOMAIN, ECHO, FTP, FTPDATA, HTTP,
SMTP, SNMP, TELNET, TFTP, and WWW. Each of these values translates into its equivalent port
number, which is used as both the start and end of the port range. This is an optional configuration.
Destination L4 Port Number
- Specify a packet's destination layer 4 port number match condition
for the selected extended IP ACL rule. This is an optional configuration.
Service Type
- Select a Service Type match condition for the extended IP ACL rule from the
pulldown menu. The possible values are IP DSCP, IP precedence, and IP TOS, which are
alternative ways of specifying a match criterion for the same Service Type field in the IP header,
however each uses a different user notation. After a selection is made the appropriate value can be
specified.
IP DSCP Configuration
Specify the IP DiffServ Code Point (DSCP) field. The DSCP is
defined as the high-order six bits of the Service Type octet in the IP header. This is an
optional configuration. Enter an integer from 0 to 63. The IP DSCP is selected by possibly
selection one of the DSCP keyword from a dropdown box. If a value is to be selected by
specifying its numeric value, then select the 'Other' option in the dropdown box and a text
box will appear where the numeric value of the DSCP can be entered.
IP Precedence Configuration
The IP Precedence field in a packet is defined as the
high-order three bits of the Service Type octet in the IP header. This is an optional
configuration. Enter an integer from 0 to 7.
IP TOS Configuration
The IP TOS field in a packet is defined as all eight bits of the Service
Type octet in the IP header. The TOS Bits value is a hexadecimal number from 00 to FF. The
TOS Mask value is a hexadecimal number from 00 to FF. The TOS Mask denotes the bit
positions in the TOS Bits value that are used for comparison against the IP TOS field in a
packet. For example, to check for an IP TOS value having bits 7 and 5 set and bit 1 clear,
where bit 7 is most significant, use a TOS Bits value of 0xA0 and a TOS Mask of 0xFF. This
is an optional configuration.
Command Buttons
Configure
- Configure the corresponding match criteria for the selected rule.
Delete
- Remove the currently selected Rule from the selected ACL. These changes will not be
retained across a power cycle unless a save configuration is performed.
