Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 719/1568
7.3.2.35
exit-overflow-interval
exit-overflow-interval
command configures the exit overflow interval for OSPF. It describes the
number of seconds after entering overflow state that a router will wait before attempting to leave the
overflow state. This allows the router to again originate non-default AS-external-LSAs. When set to 0,
the router will not leave overflow state until restarted. The range for seconds is 0 to 2147483647
seconds.
no
exit-overflow-interval
command configures the default exit overflow interval for OSPF.
Syntax
exit-overflow-interval <seconds>
no exit-overflow-interval
Default Setting
0
Command Mode
Router OSPF Config Mode
7.3.2.36
external-lsdb-limit
external-lsdb-limit
command configures the external LSDB limit for OSPF. If the value is -1, then
there is no limit. W hen the number of non-default AS-external-LSAs in a router's link-state database
reaches the external LSDB limit, the router enters overflow state. The router never holds more than the
external LSDB limit non-default AS-external-LSAs in it database. The external LSDB limit MUST be set
identically in all routers attached to the OSPF backbone and/or any regular OSPF area. The range for
limit is -1 to
2147483647.
no external-lsdb-limit
command configures the default external LSDB limit for OSPF.
Syntax
external-lsdb-limit <limit>
no external-lsdb-limit
<limit>
- The range for limit is -1 to 2147483647. If the value is -1, then there is no limitation.
Default Setting
-1
Command Mode
Router OSPF Config Mode
