Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 873/1568
8.3
MLD Commands
This section provides a detailed explanation of the MLD commands. The commands are divided into the
following different groups:
Show commands are used to display device settings, statistics and other information.
Configuration commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.
8.3.1
Show Commands
8.3.1.1 show ipv6 mld groups
Use this command to display information about multicast groups that MLD reported. The information is
displayed only when MLD is enabled on at least one interface. If MLD was not enabled on even one
interface, there is no group information to be displayed.
Syntax
show ipv6 mld groups {<slot/port> | vlan <vlan-id> | <group-address>}
<slot/port> -
Valid slot and port number separated by forward slashes.
<vlan-id> -
VLAN ID. The range of VLAN ID is 1 to 4093.
Default Setting
None
Command Mode
Privileged Exec
Display Message
The following fields are displayed as a table when <slot/port> is specified.
Group Address:
The address of the multicast group.
Interface:
Interface through which the multicast group is reachable.
Up Time:
Time elapsed in hours, minutes, and seconds since the multicast group has been known.
Expiry Time:
Time left in hours, minutes, and seconds before the entry is removed from the MLD
membership table.
When <group-address> is specified, the following fields are displayed for each multicast group and
each interface.
Interface:
Interface through which the multicast group is reachable.
Group Address:
The address of the multicast group.
