Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 973/1568
9.4.1.7
show ipv6 ospf interface
This command displays the information for the IFO object or virtual interface tables.
Syntax
show ipv6 ospf interface {<slot/port> | loopback <0-7> | tunnel <0-7> | vlan <vlan-id>}
<slot/port> -
Interface number.
<0-7> -
Loopback/Tunnel Interface ID.
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
IPv6 Address:
Shows the IPv6 address of the interface.
ifIndex:
Shows the interface index number associated with the interface.
OSPF Admin Mode:
Shows whether the admin mode is enabled or disabled.
OSPF Area ID:
Shows the area ID associated with this interface.
Router Priority:
Shows the router priority. The router priority determines which router is the
designated router.
Retransmit Interval:
Shows the frequency, in seconds, at which the interface sends LSA.
Hello Interval:
Shows the frequency, in seconds, at which the interface sends Hello packets.
Dead Interval:
Shows the amount of time, in seconds, the interface waits before assuming a
neighbor is down.
LSA Ack Interval:
Shows the amount of time, in seconds, the interface waits before sending
an LSA acknowledgement after receiving an LSA.
Transmit Delay Interval:
A number representing the OSPF Transmit Delay for the specified
interface.
Authentication Type:
Shows the type of authentication the interface performs on LSAs it
receives.
Metric Cost:
Shows the priority of the path. Low costs have a higher priority than high
costs.
OSPF MTU-ignore:
Shows whether to ignore MTU mismatches in database descriptor
packets sent from neighboring routers.
