Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 783/1568
7.10.2.12 set interface
If network administrator does not want to revert to normal forwarding but instead want to drop a packet
that does not match the specified criteria, a set statement needs to be configured to route the packets to
interface null 0 as the last entry in the route-map.
set interface null0
needs to be configured in a
separate statement. It should not be added along with any other statement having other match/set
terms.
A route-map statement that is used for PBR is configured as permit or deny. If the statement is marked
as deny, traditional destination-based routing is performed on the packet meeting the match criteria. If
the statement is marked as permit, and if the packet meets all the match criteria, then set commands in
the route-map statement are applied. If no match is found in the route-map, the packet is not dropped;
instead the packet is forwarded using the routing decision taken by performing destination-based
routing.
To remove a set term from a route map, use the
no
form of this command.
Syntax
set interface null0
no set interface null0
Default Setting
None.
Command Mode
Route Map Config
