Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 1474/1568
before OSPFv3 can become operational. This can also be done by issuing the CLI command
router-id, in the ipv6 router ospf mode.
!
Once OSPFv3 is initialized on the router, it will remain initialized until the router is reset.
Exit Overflow Interval
- Enter the number of seconds that, after entering overflow state, the router
should wait before attempting to leave overflow state. This allows the router to again originate
non-default AS-external-LSAs. If you enter 0, the router will not leave Overflow State until restarted.
The range is 0 to 2147483647 seconds.
External LSDB Limit
- The maximum number of AS-External-LSAs that can be stored in the
database. A value of -1 implies there is no limit on the number that can be saved. The valid range of
values is (-1 to 2147483647).
Default Metric
- Sets a default for the metric of redistributed routes. This field displays the default
metric if one has already been set or blank if not configured earlier. The valid values are (1 to
16777214)
Maximum Paths
- Configure the maximum number of paths that OSPFv3 can report to a given
destination. The valid values are 1 to 32.
AutoCost Reference Bandwidth
- Configure the auto-cost reference-bandwidth to control how
OSPF calculates default metrics for the interface. The valid values are (1 to 4294967)
Default Passive Setting
- Configure the global passive mode setting for all OSPF interfaces.
Configuring this field overwrites any present interface level passive mode setting. OSPF does not
form adjacencies on passive interfaces, but does advertise attached networks as stub networks.
Default Route Advertise
Default Information Originate
- Enable or Disable Default Route Advertise. Note that the values for
'Always', 'Metric' and 'Metric Type' can only be configured after Default Information Originate is set to
enable. If Default Information Originate is set to enable and values for 'Always', 'Metric' and 'Metric
Type' are already configured, then setting Default Information Originate back to disable will set the
'Always', 'Metric' and 'Metric Type' values to default.
Always
- Sets the router advertise ::/0 when set to "True".
Metric
- Specifies the metric of the default route. The valid values are (0 to 16777214)
Metric Type
- Sets the metric type of the default route. Valid values are External Type 1 and
External Type 2.
Helper Support Mode
- Configures how unit will act when a neighbor performs a warm restart. The
possible values are:
Planned
- Indicates that OSPF should only help a restarting neighbor during planned events.
Always
- Indicates that OSPF help a restarting neighbor during all planned and unplanned warm
restart events.
Disabled
- Disables OSPF from acting as a helpful neighbor.
Helper Strict LSA Checking
- When enabled, the unit will exit helper mode whenever the topology
changes.
