Kobelco SK55SRX-6, Руководство по эксплуатации

Страница: 54 / 311

1.8.2 DURING INSPECTION & MAINTENANCE
HOT PARTS
・ Do not remove the radiator cap immediately
after stopping operation when the coolant is
to be inspected or drained. The high
temperature coolant or steam may spout and
cause burn. Wait until the temperature of the
radiator cap goes down enough to touch it
with a bare hand and after confirming it,
slowly loosen the cap to release the internal
pressure of the radiator and then remove the
cap.
・ Do not remove the cap or plug immediately
after stopping operation when the oil is to be
inspected or drained. A spout of the high
temperature oil or contact of the hot parts
may cause burn. Wait until the temperature
of the cap or plug goes down enough to
touch it with a bare hand and after
confirming it, slowly loosen the cap or plug
to release the internal pressure and then
remove the cap or plug.
HIGH PRESSURE OIL
Internal pressure always exists in the hydraulic
circuit. Do not refill, drain the fuel, inspect or
maintain the machine before the internal pressure
becomes zero. High pressure hydraulic oil from
even a pin hole can penetrate the skin or eyes
and cause severe personal injury or blindness.
Use a cardboard and wear a face shield,
protective glasses and gloves when inspecting the
leakage location. If the high pressure oil contacts
or penetrates body, see a special doctor
immediately.
ROTATING PARTS
Rotating parts such as the fan and belts could
catch your body part and result in severe
personal injury. Stop rotation completely before
maintenance.
Place another person at the operator's seat when
you run the engine unavoidably during the engine
inspection or maintenance.
•The other person sitting on the operator's seat
should be ready to stop the engine at any time
while communicating with the person inspecting or
maintaining the engine.
[ 1. SAFETY PRECAUTIONS ]
1- 36
Copyright©2019 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2PS00017ZE08] [1226CsCshWbYs]