Kobelco SK55SRX-6, Руководство по эксплуатации

Страница: 200 / 311

4.15.2 REPLACING WATER SEPARATOR
1. Move the pilot control shut-off lever to the
"LOCKED" position and then stop the engine.
2. Open the engine hood and raise cock (2) of
the water separator to "Close" position (C).
3. Loosen ring (9) to remove case (5) and drain
the accumulated water to a container.
4. Check the water drained to the container. If
dirt is heavy, clean element (6) and inside of
case (5).
5. Remove element (6) and wash it with light
oil.
6. Replace O-ring (8) with a new one. Install
element (6) to the body of the water
separator.
7. Attach O-ring (8) to case (5) and tighten it
with ring (9).
8. Lower cock (2) to "Open" (D).
9. After draining, be sure to follow "BLEEDING
AIR FROM FUEL SYSTEM" in Chapter 4.
1. Air vent bolt
2. Fuel cock
3. Drain cock
4. Ring (red)
5. Case
6. Element
7. Spring
8. O-ring
9. Ring
A. Fuel inlet
B. Fuel outlet
C. Close
D. Open
6
4
5
C
2
3
1
D
A
B
7
Water separator
5
8
9
6
2
4
7
•Be careful not to lose red ring (4) and spring (7) in the case.
•Do not wash the element with gasoline.
[ 4. MAINTENANCE ]
4- 58
Copyright©2019 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2PS00017ZE08] [1226CsCshWbYs]