Kobelco SK55SRX-6, Руководство по эксплуатации

Страница: 131 / 311

3.14 MEASURES AFTER EMERGENCY ENGINE STOP
・ Be careful not to make an engine urgent stop for the sake of protecting the engine. Before
stopping the engine, be sure to run the engine for about five minutes under no load conditions and
low speed. Also, pay particular attention to the safety to avoid an emergency stop.
・ If you made an emergency stop unavoidably when there was an imminent danger or when a failure
occurred in this machine, take preventive measures as described below to avoid damage to the
machine and personal injury.
・ Wait for the engine and coolant to cool down, and then restart the engine.
If you stop the engine suddenly when it is running at high speed, the engine temperature rapidly
rises, which may cause a failure such as oil deterioration and seal adhesive.
1
2
3
1 1
1. After an emergency stop, set the safety control lever to the "LOCKED" position.
2. If you made an emergency stop without putting the attachment or bucket on the ground, support
bucket (2) by placing a safety block under it and chock the crawlers (1).
3. If you made an emergency stop on a slope, place chock blocks (1) at the lower side of each
crawler track.
4. Until you can restart the engine or move the machine, make the working site off-limits and set
barricades for preventing third parties from coming into the working site to ensure the safety of
surroundings.
5. When the cause of emergency stop is unknown or when repair is required, contact our authorized
dealer/distributor for repair.
6. Restart the engine after the engine coolant temperature cools down.
[ 3. MACHINE OPERATION ]
3
3- 39
Copyright©2019 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2PS00017ZE08] [1226CsCshWbYs]