5-6
［
］
5.2.1
LOADING
Use the following procedure.
WHEN USING A RAMP
A
1.
Chock the trailer tires to prevent the trailer from
moving.
2.
Use a ramp with sufficient length, width, strength
and gradient. Install the ramp so its angle (A) to the
ground is 15 degrees or less.
3.
Start the engine, and move down the control lock
lever to the "UNLOCKED" position.
4.
On the switch box, press the travel speed select
switch to set it to the LOW (1st) speed.
5.
Make sure the machine position is aligned to the
ramp before going up on the ramp, raise the dozer
(if installed), and travel slowly.
When this machine is traveling up or down the ramp, fold the arm and attachment and raise the boom to avoid
interference with the ramp or trailer bed, as shown in the figure.
When the clearance between the ramp or the trailer bed is insufficient, the machine may abruptly lean to one side
when it goes over the ramp top, and strike its arm or bucket cylinder against the trailer bed, ramp, or ground,
resulting in damage to the cylinder.
6.
When the machine comes to the required position,
slowly swing the upper structure 180 degrees.
7.
Lower the attachment/equipment slowly.
8.
Move the control lock lever to the "LOCKED"
position.
9.
Stop the engine and remove the starter key.
10. Lock the lock devices such as guards and doors.
Copyright©2020 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YY00041ZE03] [0701CsCshWbYs]
