3-29
[
3.7
AUTO IDLING STOP FUNCTION
This machine is equipped with auto idling stop function to reduce the fuel consumption and exhaust gas, due to
unnecessary engine idle time.
• When auto idling switch is on, if the engine is running the engine stops after an elapse of the specified time from
when the safety lock lever is pulled up.
• After the auto idling stops, when necessary to restart the engine, start the engine after returning the starter key
switch to ACC or OFF once and the throttle potentiometer to the low idling position. But it is impossible to start
the engine again until the buzzer stops sounding after the engine stops.
• If you would like to perform warming-up of the engine, operate the air conditioner, or use the working light
continuously with the pilot control lock lever in the "LOCKED" position, turn the auto idle stop function "OFF".
With the auto idle stop function turned “ON”, the engine stops, so that the function stops.
• When necessary to leave the operator seat, always turn the starter switch off.
• When the failure warning of "engine coolant temperature" or "coolant level” appears, or auto warming-up is
working, the auto idle stop function does not work regardless whether the auto idle stop function turns "ON" or
"OFF".
• Do not use auto idling stop mode when lifting.
B
A
1
This switch is usually set to "OFF". When the auto idling
stop function is selected, the engine stops automatically
after an elapse of the specified time with the control lock
lever (1) set to "LOCKED" position (A) during engine
operation. This function is effective in saving of fuel and
in restraint of exhaust gas by setting auto idling stop
function.
• As for the setting of the auto idle stop function, see
"Setting of auto idle stop" in Chapter 2.
• The default setting of the interval until engine stop is
60 seconds.
To change the set interval, contact your KOBELCO
authorized dealer.
• After setting control lock lever to "LOCKED" position (A), the engine changes to "DECEL" speed about 4
seconds later.
• Buzzer sounds for 5 seconds before engine stops.
3.7.1
RESTART AFTER AUTO IDLE STOP
When leaving the operator’s seat for a long time, be sure to set the starter switch to the "OFF" position.
Copyright©2020 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YY00041ZE03] [0701CsCshWbYs]