Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Справочник по командам

Страница: 1445 / 1502

mpls rsvp signalling hello
Syntax { ip | mpls } rsvp signalling hello
[ refresh { interval
helloInterval | misses helloMisses } ]
{ no | default } { ip | mpls } rsvp signalling hello
Release Information Command introduced in JunosE Release 7.3.0.
Description In Global Configuration mode, turns on or configures RSVP-TE hello support for all
RSVP-TE interfaces on the current virtual router. Automatically creates RSVP-TE or
MPLS on the current virtual router if they do not yet exist there. The
no version turns off
hello support on the current VR. The default version restores the default configuration,
in which RSVP hello support is not enabled.
In Interface Configuration mode and Subinterface Configuration mode, turns on or
configures RSVP-TE hello support on the current interface, and overrides the global
configuration. Automatically creates RSVP-TE or MPLS on the current virtual router if
they do not yet exist there. This command also creates RSVP-TE on the interface if it is
not configured there. The
no version turns off hello support on the current interface. The
default version restores the default configuration, in which RSVP hello support is not
enabled, and also restores inheritance of the configuration values from the global
configuration..
Options ip—Specifies alternative keyword for compatibility with non–E Series implementations
•
•
helloInterval —Number of milliseconds specifying the interval at which hellos are sent,
in the range 1000–60000; default value is 10000
•
helloMisses —Number of RSVP-TE hello messages from a peer that can be missed
before that hello adjacency peer is considered to be down, in the range 4–10; default
value is 4
Mode Global Configuration, Interface Configuration, Subinterface Configuration
1401 Copyright © 2010, Juniper Networks, Inc.
Chapter 13: M Commands