Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Справочник по командам

Страница: 914 / 1502

ip nat pool
Syntax ip nat pool name [ startIpAddress endIpAddress ]
{ netmask networkMask | prefix-length length }
no ip nat pool name
Release Information Command introduced before JunosE Release 7.1.0.
Description Creates an address pool from which the NAT router obtains an address when performing
a dynamic translation. You can create address pools with either a single range or multiple,
nonoverlapping ranges. The
no version removes the NAT pool.
NOTE: The router will not allow you to remove a pool that has allocations outstanding.
Before removing this type of pool, you must remove the dynamic translation, clear any
outstanding translations, and then remove the pool.
CAUTION: Specifying a range in “single line” mode from the CLI replaces all other ranges.
You cannot specify a range in this mode if any existing ranges are in use. To add
additional ranges, issue this command to access IP NAT Pool Configuration mode.
Options
•
name —Name of the address pool; 32 alphanumeric characters maximum
•
startIpAddress —First IP address (inclusive) in the NAT pool range you are creating;
omitting this value in the command (along with endIpAddress ) launches the IP NAT
Pool Configuration mode, in which you can enter multiple, discontinuous ranges
•
endIpAddress —Last IP address (inclusive) in the NAT pool range you are creating;
omitting this value in the command (along with startIpAddress ) accesses IP NAT Pool
Configuration mode, in which you can enter multiple, discontinuous ranges
•
ipAddressMask— Subnet mask for any NAT pool ranges you specify
•
length —Length of the network prefix; the number of bits masking the base address
that results in the address that you want to match
Mode Global Configuration
Copyright © 2010, Juniper Networks, Inc. 870
JunosE 11.2.x Command Reference Guide A to M