Juniper JUNOS OS 10.3 - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010, Справочник по командам

Страница: 530 / 1502

debug ip rip
Syntax debug ip rip ripLog [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ]
no debug ip rip ripLog
Release Information Command introduced before JunosE Release 7.1.0.
Description Shows information about the selected variable. The no version disables the display.
Options ripLog— RIP log of interest; one of the following options:
•
•
events—General RIP events, such as removing RIP from an interface or creating the
RIP process
•
route—Events associated with two RIP routers exchanging routes
•
severity—Specifies the minimum severity of the log messages displayed for the selected
category; described either by a descriptive term—
severityValue —or by a corresponding
number— severityNumber —in the range 0–7; the lower the number, the higher the
priority:
•
emergency or 0—System unusable
•
alert or 1—Immediate action needed
•
critical or 2—Critical condition exists
•
error or 3—Error condition
•
warning or 4—Warning condition
•
notice or 5—Normal but significant condition
•
info or 6—Informational message
•
debug or 7—Debug message
•
verbosityLevel —Verbosity of the log category's messages; can be any of the following:
•
low—Terse
•
medium—Moderate detail
•
high—Verbose
Mode Privileged Exec
Copyright © 2010, Juniper Networks, Inc. 486
JunosE 11.2.x Command Reference Guide A to M